Power Options

USB cable (bus-powered)

Power over Ethernet (PoE)

• Includes IEEE 802.11af compliant RJ45 connector
• Compatible with existing PoE switches and routers

External Power Supply

LED Indicators

Additional LED indicators for power and USB activity

Indicators are oriented so they can all be easily viewed during debug

Configuration and Test

Bh560v2Config - Comprehensive Graphical Configuration and Diagnostic Tool

• Operates over USB and LAN
• Automatically locates (searches for) XDS560v2 units connected via USB and on the network (LAN)
• Set Device Parameters, such as TCP/IP address
• Tests target connection and scan chain integrity
• Performs in-field firmware upgrades

Development Environment and Operating Systems

Compatible with CCS v4.2 and later

Windows XP/Vista/7 & 2003 Server (32 and 64-bit editions)

Linux

Debug Interfaces

Supports IEEE 1149.1 (JTAG)

Supports IEEE 1149.7

System Trace Support

• Mobile Industry Processor Interface (MIPI)
• System Trace Protocol (STP)
• 1-4 pin System Trace
• 128 MByte System Trace Buffer

See Blackhawk's Enhanced Debug Interface Utility Bh560v2Config:

For BH560v2 setup, configuration, and test, Blackhawk also includes a graphical user interface application (Bh560v2Config).

Bh560v2Config makes it possible to easily setup and configure network settings, search for XDS560v2 devices on the local area network (LAN), assign a name to the units, and more.

You can also perform simple tests, including JTAG scans of the target to verify communication.

TI Embedded Processor Support

C2000, C5000, C6000, ARM, ARM Cortex, Sitara, OMAP, DaVinci, TMS470, TMS570, Stellaris and more

Compatible with CTools enabled devices

Target Physical Connections

60-pin MIPI

20-pin ARM Multi-ICE (via pin converter)

14-pin TI (via pin converter)

20-pin cTI (via pin converter)

60-pin TI Trace (via pin converter)

Target Cable

High-Speed Data Coax Ribbon Cable (12.5 inches) with

Native 60-pin MIPI HSPT Buffer Board

Target Electrical and Signal Interface

Auto-sensing target voltage range from 1.2 to 4.1 volts

Auto-Adaptive Tesk Clock (TCK) up to 50 MHz

100MHz Export Clock compliant to MIPI STP

ESD Protection on target and host connections

Detection of target power loss and cable disconnects

Auto -compensating calibration for edge jitter, channel skew and duty cycle

Adaptive receiver for setup/hold times (up to 1.5ns)

Indicators

Three Activity LEDs (red, green, and amber)

Three State LEDs (red, green, and amber)

See Blackhawk's Enhanced Indicators Enhanced Indicators:

We added dedicated power and USB activity LEDs, similar to the ones found on our current  Blackhawk USB560m and LAN560 models. 

And... all LEDs are oriented on the same end panel so they can all be easily viewed during debug. So, you won't have to fumble with the emulator pod to see status.

Host Interfaces

High-Speed USB 2.0 (480Mb/s)

10/100Mb Ethernet (LAN)

Power Options

External Power Supply Brick

See Blackhawk's Enhanced Power Options Enhanced Power Options:

USB
Yes, the Bh560v2 is designed to be powered soley from USB!

PoE
The Bh560v2 includes an IEEE 802.11af Power Over Ethernet (PoE) connector that can be powered from a PoE enabled switch (or external PoE injector supply).