TAP Protection Adapter

Transient Suppression for Corelis JTAG Controllers

  • Transient voltage suppression for ESD, EFT, and lightning events
  • Integrated 10-Ohm series resistors for current limiting
  • IEC 61000−4−2 Level 4 ESD protection
  • Short 3” cable length between JTAG controller and adapter minimizes performance impact

Low Voltage Adapter

TAP Adapter for Corelis JTAG Controllers

  • Converts JTAG signal levels between a TTL scan controller and a low voltage Unit Under Test (UUT).
  • Supports clock speeds up to 100 MHz.
  • Automatically detects and matches UUT reference voltage levels between 0.4V and 2.5V based on UUT connector pin.
  • Capable of driving output signals up to 90 mA, readily accommodating 50 ohm loads.

ScanTAP IsoPod

Complete TAP Signal Isolation for Corelis Boundary-Scan Controllers

  • 4 kV isolation barrier helps prevent damage to hardware
  • 3.3 V TAP interface; Supports I2C and SPI programming speeds up to 1 MHz
  • Supports JTAG test clock (TCK) frequencies up to 40 MHz
  • Supports I2C and SPI programming speeds up to 1 MHz